three main aspects to the first aspect is the most important at the plate, because the furniture environmental performance mainly reflected on the plate, particularly low formaldehyde content good plate, three main categories, E2 level which is consistent with national standards , E1 level in line with European standards, E0 class is among the most environmentally friendly world-class standards.

domestic production of sheet metal can now reach level E0 is not, a few of the one or two energy level E1. European forest resources rich country imports most of the plate can reach E1 standard, which is selected from the plate. If the conditions we must choose more than E1 class environmental performance better.

E2,10-30 mg / 100 g; E1, equal to less than 1.5 mg / L; E0, equal to less than 0.5 mg / L. Second from the finish, the decorative plates veneer used in relatively good corporate wear resistance to draw without fading. Some of the difference between finishing first, wear is not enough, and second, after three to six months, gradually fading, yellowing effect.

buy green furniture attention to the problem, first look at the color of the plate, and pick your favorite popular color, but also a closer look at the production process, including Edge, furniture structure is reasonable, focused primarily on the use of hardware and durable coefficient, generally imported hardware life is thousands of times, the equivalent of twenty years. The second is to look at

smell, environmentally friendly furniture should be no irritating smell, does not irritate the eyes, nose, and throat. Wen mainly for formaldehyde emission from the lower content of formaldehyde environmentally friendly furniture increasingly good, but at the same time ensuring the strength is as low as possible. It is recommended to look at the smell while manufacturers presented a certificate, the formaldehyde content of the commitments do not trust the manufacturers to furniture to the authority for testing. Look at the issue depends on the cross-sectional furniture plate, which is equal to the surface really good, really fresh green sheet is made of wood, they are able to see the future cut white fresh substrate, relatively large particles.

buy furniture tips

1, it is used to identify the furniture or paper veneer wood veneer, which is more difficult. The easiest way is to observe patterns, veneer natural knots, color and texture changes.

2, panel furniture Edge is very important. Pay attention to the merits of edge material, note there is no edge is not flat, tilt phenomenon. Particular attention is that it is not all six sides Edge - although using formaldehyde-free adhesives, but wood-based panels in the production process will be more or less volatile gases, sealing tight for room Of course, environmental benefits.

3, firmness depends on the structure of the furniture. First, the gap between the furniture door drawer joints, if a large gap, indicating that rough work, a long time will be deformed; the second is a single or double pack boxes pack boxes, usually, in addition to outside layer board, which also furniture It should be covered with a thin panel, called double-pack boxes, furniture, both beautiful and strong double-pack box.

4, good or bad, of course, it must also bear paint. Are pigments streak? Angular position of the pigment whether coated too thick? Cracks or air bubbles it? These are carefully view. He had asked the salesperson, a few furniture finishes. Of course, is the number of times the better.

5, hinge from the slot and can be seen at the drill furniture wood or medium density particleboard, the best approach is to carefully observe the hinge slot and drill at a place exposed internal structure, it can be seen with a particleboard or MDF.

6, the use of hardware, free entry is a combination of the biggest advantages of furniture, so the quality is good or bad quality of the furniture and fittings are closely related. Imported furniture is expensive expensive on these minutiae.

& nbsp;